To paraphrase Samuel Johnson, there was a time when 3D metal printing was like a dog walking on his hind legs – it wasn't done well; but you were surprised to find it done at all. Now that laser sintering or Selective Laser Melting (SLM) is used for everything from printing rocket engine components to semi-automatic pistols, the time for surprise may b long past, but the technology still has plenty of room for improvement. That's why researchers at the Lawrence Livermore National Laboratory (LLNL) are working on simulations to improve the speed of 3D laser printing and the quality of the final product by using higher-powered lasers... Continue Reading LLNL improving the efficiency of 3D metal printing
Section: Science
Tags: 3D Printing, Laser, Lawrence Livermore National Laboratory, Manufacturing,Simulations, Stainless Steel
Related Articles:
Micro laser sintering technology to 3D print tiny metal parts
Arup uses 3D printing to create structural steel components
World record 1 megajoule laser shot hits target
NASA using 3D laser printing to create complex rocket parts
Layered fabrication now growing solid metal parts
NASA 3D-prints and fires rocket engine component
No comments:
Post a Comment
Rules for submitting comments:
1. No profanity. I maintain the pretense that this is a family-friendly site.
2. Stay on topic. A bit of straying and off-hand commenting is okay, but hijacking the discussion is right out.
3. No ad hominem attacks. Attack the subject, not the other person on the thread and keep the discussion civil.
4. No spamming or commercial endorsements. These get deleted immediately.
Tip: Beware of putting hyperlinks in your comments–especially at the end. For some reason, Blogger interprets these as spam.
Note: Due to the recent spate of anonymous spamming, registration for comments is now required.